Replacing A Failed Disk - NETGEAR MS2110-100NAS User Manual

NETGEAR Stora User Manual

Replacing a Failed Disk

When a disk fails in your Stora device, you are notified of the failure by e-mail. On the front of
the Stora device, an amber LED might indicate a failed disk. The top LED is disk 1; the
bottom one is disk 2. Take note of the failed disk.
To assure compatibility, check the Hardware Compatibility list on the NETGEAR support site
for a list of disks qualified to be used in the Stora.
WARNING!
Be sure to power down the unit and then unplug Stora power cord
before adding or removing the disks. Failure to observe this
precaution by "hot-swapping" a drive could render your disks
useless.
To Eject a Disk
1. Open Stora application user interface.
2. Click Preferences.
3. Navigate to Administration > Disk Management
4. Click the Eject button.
See "Disk Management" on page 106 for more information on ejecting disks.
Figure 17 Safely eject a disk from your Stora
Chapter 1: Getting Acquainted | 25