Powering On The Server; Factory Image; Physical Configuration; Hp Proliant Hardware Raid Configurations - HP DL320s - ProLiant 9TB SATA Storage Server NAS User Manual

• ProLiant Essentials Integrated Lights-Out 2 Advanced Pack

Powering on the server

Power on the server after connecting the cables. For more information on your storage server model's
hardware components, see
1.
Power on server by pushing the power button. The power LED illuminates green.
2.
When the server powers on, an installation progress screen is displayed. The installation process
takes approximately 10 to 15 minutes to complete and the server will reboot twice. No user
interaction is required.
CAUTION:
Do not interrupt the installation process; when the installation sequence is complete, the
system prompt appears.
3.
Go to "Accessing the HP Storage Server Management

Factory image

HP ProLiant Storage Servers are preconfigured with default storage settings and preinstalled with either the
Windows Storage Server 2003 R2 operating system or the Microsoft® Windows® Unified Data Storage
Server 2003 operating system. This section provides additional details about the preconfigured storage.
Physical configuration
The logical disks reside on physical drivess as shown in
configurations" on page 18. The DON'T ERASE volume contains an image that is deployed onto the
OS partition during system installation.
Table 4 HP ProLiant hardware RAID configurations
Logical Disk 1
•
ML310
G4
•
•
•
DL585
G2
•
•
NOTE:
In the HP Array Configuration Utility (ACU), logical disks are labeled 1 and 2. In Microsoft Disk
Manager, logical disks are displayed as 0 and 1. For HP Smart Array configuration information, see
http://h18004.www1.hp.com/products/servers/proliantstorage/arraycontrollers/.
The DON'T ERASE logical disk supports the recovery process only and does not host a secondary
operating system. If the operating system has a failure that might result from corrupt system files, a corrupt
registry, or the system hangs during boot, see
If the data volume is not carved at the factory or during the installation process, it must be configured
manually by the end user. Be sure to back up your user data, and then use the System Recovery DVD to
restore the server to the factory default state as soon as conveniently possible.
18
Installing and configuring the server
"Server components" on page 123.
Operating System Volume
RAID 5
Physical Drives 0–3
Operating System Volume
RAID 5
Physical Drives 0–1
console" on page 19 to set up server access.
"HP ProLiant hardware RAID
Logical Disk 2
• DON'T ERASE Volume
• RAID 5
• Physical Drives 0–3
• DON'T ERASE Volume
• RAID 5
• Physical Drives 0–1
"System recovery" on page 121.
Logical Disk 3
• Data Volume
• RAID 5
• Physical Drives 0–3
N/A