HP DL320s - ProLiant 9TB SATA Storage Server NAS User Manual page 24

The Integrated Lights-Out port on the storage server can be configured through the Rapid Startup Wizard
or through the iLO 2 ROM-Based Setup Utility (RBSU). SNMP is enabled and the Insight Management
Agents are preinstalled.
The HP iLO 2 management processor provides multiple ways to configure, update, operate, and manage
servers remotely. The HP ProLiant Storage Server comes preconfigured with iLO 2 default factory settings,
including a default user account and password. These settings can be found on the iLO 2 Default
Network Settings tag found on the front of the server. If iLO 2 is connected to a network running DNS
and DHCP, you can use it immediately without changing any settings.
For more information on using HP iLO 2, see the HP Integrated Lights-Out 2 User Guide.
To quickly set up iLO 2 using the default settings for iLO 2 Standard and iLO 2 Advanced features,
follow the steps below
1.
Ensure that a network cable is connected to the iLO 2 port located on the back of the storage server.
NOTE:
This connection method is easiest when the connection is to a DHCP and DNS supported
network.
2.
If you are not using dynamic DHCP (IP addressing), you will need to input a static IP address by
using the direct attach method and the iLO 2 RBSU.
3.
Using the methods described in the HP Integrated Lights–Out 2 User Guide, connect to the iLO 2 port.
NOTE:
To find the default iLO 2 log on settings, see the iLO 2 Default Network Settings card
attached to your server. The default DNS, administrator name, and password needed to
log on will be on this card.
4. If desired, you can change the default user name and password on the administrator account to
your predefined selections.
5.
Set up your user accounts, if using the local accounts feature.
6.
Activate iLO 2 advanced features by entering a license key from the included ProLiant Essentials
Integrated Lights-Out 2 Advanced Pack.
7.
Access the HP ProLiant Storage Server using the iLO 2 Remote Console functionality. Log on to
the HP ProLiant Storage Server with the default user name administrator and the password
hpinvent. The HP ProLiant Storage Server Management console starts automatically.
NOTE:
When the Remote Console feature is enabled, you can get access to the storage server's
login screen.
The Integrated Lights-Out 2 port comes with factory default settings, which the administrator can change.
Administrators may want to add users, change SNMP trap destinations, or change networking settings.
See the HP Integrated Lights-Out 2 User Guide for information about changing these settings. To obtain
this guide, go to http://www.hp.com/support/manuals, navigate to the servers section, and select
Server management. In the ProLiant Essentials Software section, select HP Integrated Lights-Out 2 (iLO
2) Standard Firmware.
24
Installing and configuring the server