Pbx Interface Parameters - Panasonic KX-TVA594 Installation Manual

5.2 PBX Settings for Inband Integration
5.2.3

PBX Interface Parameters

The following items can be programmed using KX-TVA Maintenance Console under "System
Parameters" by selecting the "Parameters" tab.
PBX Environment
• PBX Type
Specifies the type of PBX which is connected to the VPS.
• Integration Mode
Select "Inband". If PBX type is set to the Panasonic KX-T series, the Inband Signaling
parameters are set automatically and should not be altered.
SEQUENCE CODES
0-9,
• Maximum Extension Number Length
Specifies the maximum number of digits that the connected PBX recognizes as an extension
number.
• Extension Number of VPS Port
Specifies the extension number for each VPS port on the connected PBX.
Note
• Extension numbers of the VPS ports will automatically be assigned when the PBX type has
been changed.
• Operator Transfer Sequence
Tells the VPS how to transfer a call to the operator.
Example: FTX [hookswitch flash
• Extension Transfer Sequence
Tells the VPS how to transfer a call to an extension.
Example: FTX [hookswitch flash
• Alternate Extension Transfer Sequence
Tells the VPS how to transfer a call to an extension that belongs to the "Alternate Extension
Group". This is useful for extensions that need a special transfer procedure (i.e., blind transfer)
such as modem extensions.
Example: FTXD [hookswitch flash
132 Installation Manual
D Disconnect
F Hookswitch Flash
R Ring Detection
T Dial Tone Detection
X Dial Extension
, Dialing Pause (default 1 s)
; Dialing Pause (default 3 s)
DTMF Tones
, #
dial tone dial (operator) extn.]
dial tone dial extn.]
dial tone dial extn. hang up]