Lexicon 960L V2.5 - INSTALLATION AND RELEASE NOTES REV Installation Instructions Manual page 5

960L Version 2.5 Software
4. Press 1 to begin the LARC2 update. This is the longest phase of the process, lasting about 10
minutes. The LARC2 will display a progress indicator. After the LARC 2 update is complete, the
following message will appear:
Please enter serial number of the 960L from the back panel of
the 960L chassis. Do not use the serial number of the LARC2!
Enter numbers only. Do not enter first letter (shown as
Use minus for
with ENTER.
x_
Note:
When reinstalling Version 2.5, the unit will not ask to have the serial number re-
entered if this process was completed during a previous installation.
5. Enter the serial number as it appears on the back panel of the 960L mainframe. Do not enter
the first letter. Enter the numbers and the dash only. Press ENTER when finished. The
following message will appear:
Please re-enter serial number for verification . . .
x_
6. Enter the serial number again as it appears on the back panel of the 960L mainframe. Once
again, do not enter the first letter of the serial number. Enter the numbers and the dash only.
Press ENTER when finished and the system will start.
7. After the system has started, verify that the software has been installed properly. To do this,
press the CONTROL button, then the SYSTEM button, and read the version information on
the screen. The LARC2 version is 2.4R and the mainframe version is 2.5R Build 1.
Once this process is complete, configure the system and continue working. It is recommended to
read the 960L Owner's Manual, particularly the Version 2.5 addendum, for more information
about the new software.
Installation Instructions & Release Notes
- : Use left arrow < for backspace : Finish
x )
5