Memory Offset Tuning; Moving Memory Data To The Vfo - Yaesu VR-160 Operating Manual

M M
EMORY
Once you have recalled a particular memory channel, you may easily tune off that channel,
as though you were in the "VFO" mode.
1. With the VR-160 in the "MR" (Memory Recall) mode, select
the desired memory channel.
2. Press the [ F/W ] key, then press the [ V/M ] key to activate the
"Memory Tuning" feature. The "
with " " and the Memory Channel number will be replaced
with "TUN".
3. Rotate the DIAL knob, as desired, to tune to a new frequency.
The synthesizer steps selected for VFO operation on the current
band will be the steps used during Memory Tuning.
Note: Do not forget to pull the DIAL knob to rotate the DIAL knob.
4. If you wish to return to the original memory frequency, just press the [ V/M ] key briefly.
5. If you wish to store a new frequency set during Memory Tuning, just press and hold in
the [ F/W ] key for 1/2 second, per normal memory storage procedure. The micropro-
cessor will automatically set itself to the next-available clear memory location, and
you then press [ F/W ] again to lock in the new frequency.
1) If you want to replace the original memory contents with those of the new
frequency, be sure to rotate the DIAL knob to the original memory channel
number!
2) Any required Tone Squelch/DCS changes, must be done before storing the data into
the new (or original) memory channel location.
Data stored on memory channels can easily be moved to the VFO, if you like.
1. Select the memory channel containing the frequency data to be
moved to VFO.
2. Press and hold in the [ F/W ] key for one second, then press the
[ V/M ] key. The confirmation massage (V-WRT?) will appear on
the display. Press the [ F/W ] key to cancel the Moving Memory
Data procedure, if desired.
3. Press the [ V/M ] key once more. The data will now have been
copied to the VFO, although the original memory contents will
remain intact on the previously stored channel.
36
ODE R
M
M M
M C
O T
" icon will be replaced
D
VR-160 O
O
VFO
M