Changing The Channel Steps - Yaesu VR-160 Operating Manual

A
DVANCED
The VR-160's frequency synthesizer provides the option of utilizing channel steps of 5/
8.33/9/10/12.5/15/20/25/50/100 kHz per step (optional values differ depending on the band
selected). A number of steps may be important to your operating requirements. Automatic
("AUTO") step selection is based on the current operating frequency. The VR-160 is set
up at the factory in the "AUTO" configuration, which probably is satisfactory for most
operation. However, if you need to change the channel step increments, the procedure to
do so is very easy.
1. Press and hold in the [ BANK ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 52: STEP FRE-
QUENCY.
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ BANK ] key briefly to enable adjustment of this Item.
4. Rotate the DIAL knob to select the new channel step size.
5. When you have made your selection, press and hold in the
[ BANK ] key for one second to save the new setting and return
to normal operation.
1) 9 kHz steps are available only when receiving on the BC band.
2) 8.33 kHz steps are available only when receiving on the Air band.
3) While operating on the BC band, you may only select channel steps of 9
kHz or 10 kHz; the other step selections are disabled.
4) 5 kHz steps are not available for use on 250 - 300 MHz, nor above 580 MHz.
20
O
PERATION
C C S
VR-160 O M