Autodialer Playback, Dtmf Decoder - Yaesu FT-50 Instruction Manual

If you make a mistake, hold the knob for %-second to
clear all entries for that memory and re-enter all the
d i g i t s ,
tarily to revert to the edit display. You can turn the
knob to review your stored number, or press the
key corresponding to that memory to replay it.
store, press a numbered key, as before, corre-
sponding to the desired memory number. Other-
wise, pressing the PTT again exits to the frequency
display.
digits, as desired.
display.
Note - The non-numeric DTMF tones map to the
FTT-12 keypad as follows:
A
Display
I e
Autodialer Playback
You can manually check the contents of DTMF auto-
dial memories while EZi is displayed. Also use this to
play back stored memories into a telephone.
key to display and play that DTMF memory. Turn
the knob to review each stored digit.
first ensure the DTMF memory mode is on (6%
displayed).
dial memory to transmit. Once the DTMF sequence
has begun, you can release the PTT.
DTMF Decoder
You can use a reserved, read-only, autodialer mem-
ory (c -S) to display and store DTMF sequences
decoded off-the-air as they are received:
expect to receive DTMF transmissions, hold ?'I for
%-second, then press SF5 to select autodial mem-
stored into C-9. The digits scroll from right to left as
the are decoded, and up to 32 digits can be stored.
Any additional digits overwrite previous ones, on a
first-in, first-out basis.
for ?&second.