NEC LCD2010 - MultiSync - 20.1" LCD Monitor User Manual page 38

E - 23
Troubleshooting/Support
Problem
No picture
Power Button does
not respond
Image persistence
CN971B/LCD2010X/7A812101
Check These Items
- The signal cable should be completely connected
to the display card/computer.
- The display card should be completely seated in its
slot.
- Power button and computer power switch should
be in the ON position.
- Check to make sure that a supported mode has been
selected on the display card or system being used.
(Please consult display card or system manual to
change graphics mode.)
- Check the monitor and your display card with
respect to compatibility and recommended settings.
- Check the signal cable connector for bent or pushed-
in pins.
- Check the signal input, DVI or D-SUB.
Unplug the power cord of the monitor from the AC
outlet to turn off and reset the monitor, or
simultaneously press the RESET and Power buttons.
Image persistence is when a "ghost" of an image
remains on the screen even after the monitor has been
turned off. Unlike CRT monitors, LCD monitors'
image persistence is not permanent. To alleviate
image persistence, turn the monitor off for as long as
an image was displayed. If an image was on the
monitor for one hour and a "ghost" of that image
remains, the monitor should be turned off for one
hour to erase the image.
NOTE: As with all personal display devices, NEC-
MITSUBISHI ELECTRONICS DISPLAY recommends
using a screen saver at regular intervals whenever
the screen is idle.
38
Troubleshooting/Support
00.8.30, 2:21 PM