Kuryakyn 5644 Installation Instructions

REAR OIL PANEL ACCENT FOR INDIAN
Thank You For Choosing Küryakyn!
Protect yourself and others from potential injury and property damage or loss. Pay close attention to all instructions, warnings, cautions, and notices
regarding the installation, use, and care of this product.
ENSURE THAT THE FOLLOWING PARTS HAVE BEEN INCLUDED IN THE KIT:
1 Rear Oil Panel Accent
1 Alcohol Pad
1 Installation Instructions
YOU WILL ALSO NEED:
Warm, soapy water and clean rag, masking or painter's tape, marker
STEP 1 Read and understand all steps in the instructions before starting the installation. Park the motorcycle on a hard, level surface and turn
IGN OFF. Allow the engine to cool completely.
STEP 2 Refer to PIC 1. Using warm soapy water and a clean rag, remove all dirt and
debris from the installation area; allow the area to dry completely.
Wipe the installation area with the included alcohol pad to remove any wax or
polish; allow the area to dry completely.
STEP 3 Test fit the Accent as shown in PIC 2. Use masking tape to make alignment
marks; remove the Accent.
STEP 4 Use your fingernail to rub the adhesive backing; this will activate the adhesive.
Remove and discard the backing.
STEP 5 Align the Accent; press into place for one minute; full bonding will occur after 24
hours. Remove and discard the masking tape.
NOTE: If the bike is going to be operated before full bonding occurs, secure the Accent to the fairing with a good quality
masking or painter's tape.
5644-11MC-1015
This indication alerts you to the fact that ignoring the contents described herein may negatively affect product per-
formance and functionality or damage the product itself or the product to which it is being attached.
Ensure proper adhesion of this product. Remove all grease,
oil, bugs, dirt, and other debris (including wax and polish)
from the installation area. Kuryakyn will not provide warran-
ty coverage on products or components lost or damaged
due to improper installation.
Do not attempt this installation in temperatures below 50°F
(10°C). Proper adhesive bonding ONLY occurs above 50°F
(10°C).
PIC 1
CLEAN + DRY
PIC 2
5644
Page 1