VEVOR 840281542109 Installation

MESH SAFETY POOL COVER
Safety Pool Covers
tensile strength, awesome water flow property , and excellent transmittance . The
mesh pool cover provides safety, convenience and energy efficiency to swimming
pool owners. Covering pool with a safety cover prevents your family members and
pets from falling into the pool.
Installation
A pool safety cover is secured into the deck via straps, springs, and anchors.
The brass anchors thread up to install the cover and thread down flush into the
deck when the cover is removed. Installing your own safety pool cover is an easy
DIY project, and takes only a few hours to complete.
WARNING: Always wear goggles or other appropriate eye protection while
installing anchors or other pool equipment using power tools.
SET ANCHOR
Drill about 1-5/8'' inches into the
deck using a rotary hammer drill
with a 3/4 inch masonry bit.
Vacuum or flush out the concrete
dust in the bottom of the hole.
ATTACHING SPRINGS
STEP 1
SQUARE RING
Pass the strap under the front
of the spring and through
the middle of the square ring.


After adjusting the anchors with hex key, Slide the spring onto the end of the rod until it is
approximately 6" up the end of the rod. Leverage the rod onto the insert and push the spring
down into position with your shoe (never use your hand).With the spring over the insert, pull
the rod out. If there is too much tension on the spring, loosen the strap and follow the fastening
procedures again.
Slide spring with tension bar
with best combination of abrasion resistance, tear strength,
Insert anchors to the hole
by a hammer until it is flush
with the pool deck.
STEP 3
Finish
Loop the strap over the top of
the square ring and back under
the front of the spring and pull tight.
If removing the pool cover,rotate
tension bar to disassemble springs
Insert
Adjust insert up to 1/2''
with hex key
STEP 2
How to remove?