Delay / Sampler; Delays - DigiTech RP12 Owner's Manual

RP-12 Owner's Manual
Delays/Sampler
Module Name
Mono Delay x.x
2Tap Delay x.x
4Tap Delay x.x
Stereo Delay
Modulated Delay
Sampler

Delays

Module Abbrv. Description
Dly x.x 1-tap digital delay
2TDly x.x 2-tap digital delay
4TDly x.x 4-tap digital delay
SDly Stereo digital delay
ModDly Digital delay with pitch modulation
Smpl1.5 1.5 second sampler
All the delays in this group have the same basic Parameters for con-
trolling the behavior of the Module. General Parameters include: Delay
On/Off, Delay Level, Delay Time, Delay Feedback, and Delay Repeat
Hold. The only differences between them lie in the number of taps
available and the total amount of delay time. The multi-tap delays also
include independent delay time controls for each tap with a feedback
control on the last tap in the series. Modulated Delay sounds like a
delayed chorus due to the pitch modulation.
Each delay Module has a number that immediately follows the name.
These numbers represent, in seconds, the amount of delay time avail-
able to each Module. For example, if the Module name shown in the
display reads MONO DELAY 1.4S, you know that the Module has a
maximum of 1.4 seconds of delay time available.
The available delay time ranges are 0.4 seconds (400 milliseconds),
0.5 seconds (500 milliseconds), 0.8 seconds (800 milliseconds), 1.0
seconds (1000 milliseconds), and 1.4 seconds (1400 milliseconds).
Delay Parameters are as follows:
Delay On / Off ...............Turns the delay Module either on or off. When
Delay Level ...................Controls the level of the delay Module.
Delay Time (Tap #) .......Controls the delay time of the tap indicated in
Modules are turned off, their Parameters dis-
appear from the Parameter menu. To see the
Parameters, you must turn the Module on.
Variable from 1 to 100.
the display. If a mono delay is used, no tap
number is shown. Delay time Parameters are
editable in two different ranges to give the
most flexibility and accuracy in the least
amount of scrolling time. If you press the
<UP> Parameter button when the cursor is in
Section 4 - Effects and Parameters
31