DigiTech DEATHMETAL Manual
  1. Manuals
  2. Brands
  3. DigiTech Manuals
  4. Music Pedal
  5. DEATHMETAL
  6. Manual

DigiTech DEATHMETAL Manual

Hide thumbs

Advertisement

Table of Contents

Death Metal
™
Distortion
Owner' s Manual

Advertisement

Table of Contents
loading

Related Manuals for DigiTech DEATHMETAL

Summary of Contents for DigiTech DEATHMETAL

  • Page 1 Death Metal ™ Distortion Owner’ s Manual...

  • Page 2: Declaration Of Conformity

    European Contact: Your local DigiTech Sales and Service Office or not operate normally, or has been dropped. 11.WARNING:To reduce the risk of fire or electric shock, Harman Music Group do not expose this apparatus to rain or moisture.
  • Page 3 6.The consumer forfeits the benefits of this warranty if the product's main assembly is opened and tam- pered with by anyone other than a certified DigiTech technician or, if the product is used with AC volt- ages outside of the range suggested by the manufacturer.

  • Page 4: Level Knob

    Controls the boost or cut of low frequencies. Turn this knob clockwise to increase the low frequency content, and counter-clockwise to decrease the low frequency content. 3. AC Adapter Jack Connect a DigiTech PS200R power supply to this jack. Use the proper supply for your area’s Mains line voltage.
  • Page 5 2 3 4...
  • Page 6 4. Mid Knob Controls the boost or cut of mid frequencies. Turn this knob clockwise to increase the mid frequency content, and counter-clockwise to decrease the mid frequency content. 5. High Knob Controls the boost or cut of high frequencies. Turn this knob clockwise to increase the high frequency content, and counter-clockwise to decrease the high frequency content.

  • Page 7: Indicator Led

    11. Out 2 (Mixer) Jack This output features DigiTech’s speaker cabinet emulation, that lets you run the pedal directly into a mixer or recorder input without having to use a guitar amplifier.
  • Page 8 MIXER). The two outputs give you the following options: running into a guitar amplifier, running directly to a mixing console or recording device, or both. The MIXER output uses DigiTech’s speaker cabinet emulation for an authentic guitar amplifier sound without using an amp.

  • Page 10: Battery Replacement

    Battery Replacement 1. Using the tip of a 1/4” guitar cable, push one of the release pins in on either side of the pedal, and remove the pedal from the pedal chassis. 2. Remove the battery from the battery compartment and disconnect the battery cable.

  • Page 12: Specifications

    • Jacks - Input, Amp Out, Mixer Out FAX (801) 566-7005 • Input Impedance - 1 MOhms DigiTech is a registered trademark • Output Impedance - 100 Ohms of the Harman Music Group Inc. • Power Supply - 9V Alkaline Dry Battery •...

This manual is also suitable for:

Death metal distortion

Table of Contents