DigiTech CONTROL 2 Owner's Manual page 9

The Expression Pedal can alternatively turn on and control the Wah effect by
pressing down firmly on the toe switch (this disables control of other parameters
assigned to the Expression Pedal). Press down firmly on the toe switch again
to turn off the Wah effect and switch the pedal back to controlling the saved
expression parameters.
NOTE: Rock the Expression Pedal all the way forward and all the way back each
time you power up the Control 2.
6. Tuner
The TUNER footswitch enables and disables the tuning function in the connected
GSP. The TUNER footswitch LED lights when the Tuner is active.
When the tuner is activated, the Display briefly reads TUNER. To begin tuning, play
a note on your guitar (a harmonic at the 12th fret usually works best). The note
being played appears in the Display, and arrows indicates whether the note is sharp
or flat. An arrow pointing to the left ( ) indicates the note is sharp and should be
tuned down. An arrow pointing to the right ( ) indicates the note is flat and
should be tuned up. When your note is in tune,
7. Tempo
Press the TEMPO footswitch 2 or more times to set the time of the current
preset's Delay effect. The TEMPO LED flashes to indicate the delay time. The
Delay effect does not need to be active to set the delay time.
8. Footswitches 1-5
These footswitches are used to select presets in the active bank. The LED
adjacent to each footswitch lights to indicate which preset is selected.
9. Footswitches 6-10
These footswitches are used for turning effects on and off (5 Patch Mode) or for
selecting the second group of 5 presets in the active bank (10 Patch Mode). In 5
Patch Mode, Footswitches 6-10 act as effects on/off switches for the effect labeled
above each footswitch. When an effect is turned on or off, the LED adjacent to its
footswitch will light or darken to indicate the effect's on/off status. The number 10
footswitch is labeled CONTROL, and can be assigned a preset-specific parameter
(min/max setting or effect on/off). See page 11 for more information about
assigning parameters to the CONTROL Footswitch.
In 10 Patch Mode, each preset bank has ten presets to select from so each
numbered footswitch 1-10 will select a preset. The LED adjacent to the
footswitch will light to indicate which preset is selected. Only one of the ten
numbered footswitches can be lit at a time in 10 Patch Mode. See page 5 for more
information about 5 Patch Mode and 10 Patch Mode.
is displayed.
Control 2 Owner's Manual
Top Panel