Selecting Banks - DigiTech CONTROL 2 Owner's Manual

Using the Control 2 Remote Foot Controller

Selecting Banks

The Control 2 assigns groups of presets (called banks) to the numbered
footswitches. Each bank is a group of 5 presets (5 Patch Mode) or 10 presets
(10 Patch Mode) depending on the foot controller mode selected by the GSP.
Hence, there are 20 banks in 5 Patch Mode and 10 banks is 10 Patch Mode.
To select a new bank and a new preset, follow these steps:
Press either the Bank Down or Bank Up footswitch. The name of
1.
the newly cued bank appears in the Display and the available preset
footswitches flash (1-5 in 5 Patch Mode and 1-10 in 10 Patch Mode).
Bank Down & Bank Up
2. To make the bank shown in the Display active you must load a new
preset by pressing one of the flashing preset footswitches. If no
footswitch is pressed within 5 seconds, the Control 2 will abort the
bank change and return to the preset prior to the bank footswitch being
pressed.
Banks are also changed when selecting presets using the Edit/Select knob
on the GSP. For example, if any of presets 1-5 are selected on the GSP in 5
Patch Mode, the bank titled Presets 1-5 will be the active bank on the
Control 2 and numbered Footswitches 1-5 would select presets 1-5. If preset
6 is then selected using the Edit/Select knob on the GSP, Presets 6-10
will now become the active bank and numbered Footswitches 1-5 would then
select presets 6-10.
Note that banks titled Presets 96-99 (5 Patch Mode) and Presets
91-99 (10 Patch Mode) contain only 4 and 9 presets respectively. When one
of these banks is selected, Footswitch 5 (5 patch mode) and the CONTROL
Footswitch (10 patch mode) have no function.

Control 2 Owner's Manual