Mighty Mule FM132 Instructions

FM132 Instructions
Install the push button control at least 10 ft. (3m) from the gate.
install a push button where someone can reach through the gate to activate
it or where a person can touch the gate or gate opener while activating the
push button control.
Use GTO low voltage wire (RB509) to connect push button to
control board. Detailed wiring instructions can be found in
your gate opener instruction manual.
COM COM
Be sure wires are twisted and inserted into terminal
connections with no loose strands touching other wires or
terminal connections. Tighten set screws against exposed end
of wires.
WARNING
Mighty Mule Control Boards
GRN BLK RED
RECEIVER
Low Voltage Wire
from Push Button
SEQ1
SEQ2
ALARM ACCESSORY
NEVER
LEARN
R B G
RCVR
Low Voltage Wire
from Push Button