Titan Controls APOLLO 11 Instructions For Operation

The 240 Volt digital timer will display the current
time when operating. It will control up to twenty
(20) separate timing programs. There are many
combinations of timing programs available to the
customer. Such as: hourly, daily or weekly set-
tings. Keep Apollo
away from spray and pesticides.
To set the current day and time:
1. Hold 'SET' for three seconds.
2. Navigate to the correct day with the arrow but-
tons.
3. Press 'SET', adjust the hour with the arrow
buttons.
4. Press 'SET', adjust the minute with the arrow
buttons.
5. Press 'SET' again to finalize the day and time
adjustments.
6. If day or time is set incorrectly, repeat this pro-
cess.
NOTE: the Apollo
time as its default display mode. Hold 'TIME' for
three(3) seconds when the current time is dis-
played to toggle between 24 hour and 12 hour
time modes.
To program On/Off cycles on Apollo
1. Press the right arrow (
is displayed and '1 ON' is blinking. '1 ON' indi-
cates that you are programming the start day
and time of the first timed cycle.
2. Press 'SET', adjust ON operation days with the
arrow buttons.
3. Press 'SET', adjust the starting hour with the
arrow buttons.
4. Press 'SET', adjust the starting minute with the
arrow buttons.
5. Press 'SET', then press the right arrow (
button. '1 OFF' will begin blinking, indicating
that you are adjusting the end day and time
240 Volt Digital Timer
Instructions for Operation
11 – 240 Volt digital timer
®
11 uses 24 hour (military)
®
®
a
) button until 'PROG'
of the first timed cycle. Repeat steps 3 & 4 to
program 'OFF' time.
Continue this process for up to 20 separate ON/
OFF cycles, which will display as '2 ON', '2 OFF',
'3 ON', '3 OFF', etc. By pressing the 'MANUAL'
button at any point during the setting process
will cancel the currently selected set time. Press
the right arrow (
to review your set schedules and select them for
adjustment.
Timer Switch mode:
Press 'MANUAL' to scroll through 'AUTO OFF',
'ON', AUTO ON' and 'OFF' modes.
Countdown mode:
Press the 'CTD' button to use the countdown
function, which counts down from a user-deter-
mined length of time before powering attached
devices. Press 'TIME' + left arrow (
same time to enter the Countdown (CTD) mode
function. Then press 'SET' and set HOUR, MIN-
UTE and SECOND of countdown. Press 'CTD"
to start countdown process.
function has a maximum time length of 23 hours,
59 minutes and 59 seconds.
Random mode:
11:
Press the 'RND' button when the timer is set to
'AUTO' mode. 'RND' will appear on the right
side of the display. This randomly extends 'ON'
and 'OFF' cycles for attached 240 Volt applianc-
es from 2 to 30 minutes, which can be used as a
theft deterrent when the area is unattended.
Reset function:
Press the 'RESET' button to default to factory
settings.
NOTE: if not functioning properly, plug in for 5
minutes and press the reset button. This gener-
ally fixes any problems you may encounter.
a
)
Do not exceed 1000 Watts ballast rating
a
) button at the main screen
10 Amps/240 Volts/60 Hz.
1 year warranty

) at the
The countdown