Swing-N-Slide NE 4566L Manual

Disc Swing
Disc Swing
KIT INCLUDES:
QTY DESCRIPTION
1 Disc Swing Seat
1 Loc Nut
1 Washer
1 Bolt Cover
2 2" Galvanized Screws
INSTRUCTIONS
1. Measure and mark the bottom of the swing beam a
minimum of 15" from the nearest swing or edge of
the unit on each side as shown in Figure 1.
2. Drill one 5/16" hole up through the beam at the mark
made in Step 1. Attach the rope to the swing beam
by slipping the eye bolt through the hole and secure
it with a 5/16" flat washer and loc nut. Place a bolt
cover over the exposed bolt end and secure it using
two 2" galvanized screws (see Figure 1).
PlayCore Printed in USA
NE 4566L
2" galvanized
screws
Bolt Cover
Loc Nut
Washer
Fig. 1
LA 5240