Hopkins 43325 Installation Instructions

43325 - Vehicle Wiring Installation Instructions
7 RV Blade and 4-Wire Flat Multi-Tow Harness
Toyota Sequoia 2005-2008
1. Locate the (2) vehicle 7-way RV wiring harness plugs at the rear of vehicle above the factory 7- Way
RV socket assembly, slightly towards the driver's side. This connector harness will have the same
connector ends as the Hopkins
2. Disconnect the vehicle 7-way RV wiring harness plugs (2). Connectors will disconnect by pressing
or lifting on a locking tab and pulling apart.
3. Remove factory 7-way RV socket from vehicle 7-way mounting bracket.
4. Insert the Hopkins MT-Connector into the vehicle 7-way mounting bracket and secure with mounting
bolts (Provided) or mount Hopkins 7-way mounting bracket and secure w/mounting bolts. (Provided)
5. Route the wire harness from the Hopkins MT-Connector to the (2) vehicle plugs. Connect the plugs
making sure the connectors are fully inserted
6. Plug trailer connector/s into 4-way and 7-way receptacles and test all functions with the engine
running to ensure proper operation.
TIPS:
-Grease should be applied to the wiring terminals on a regular basis to help prevent corrosion.
-A heavy duty flasher may be required to eliminate rapid flashing.
-Always unplug boat trailer connector before backing trailer into the water.
®
MT-Connector.