1.0 Important Safety Information Thank you for purchasing this SYMA product. To ensure that you operate the drone correctly and conveniently, please read these instructions carefully before first use and store them safely for future reference. 1. To protect the legitimate rights and interests of users, please be sure to read the contents of this manual carefully before using this product.
11. Please keep a safe distance from the spinning propellers to avoid injury. 12. To ensure the electromagnetic environment requirement of the aviation radio (station), using remote controls in the zone, which is in a radius of about 5000m zones from the circle center of the airport runway, is forbidden.
2.0 Product Description 2.1 Specifications Drone Brand Name SYMA Model/ITEM NO. X660 Drone weight about 24g Drone size 120x120x45 mm Range Motor ø6 Battery capacity 3.7V 200mAh Charging time about 40 minutes Flight time about 7 minutes Remote control Operating frequency 2.4 GHz...
2.3 Remote Control Diagram Left joystick(short Right joystick(short press to change the press to switch light effects; press and between high and low hold for trimming speed mode) adjustment and release when finished; to clear trimming settings, press and hold simultaneously with Power switch the power button)
Important: Battery Charging Information 1. Rechargeable batteries should only be charged under adult supervision. 2. Caution: Risk of explosion if the battery is replaced with incorrect ones. Please dispose of the batteries according to the instructions. 3. Don't use or place batteries near heat sources such as fires or heaters. 4.After flying, do not charge the battery immediately to avoid overheating and potential fire hazards.
3.0 Flight Guide 3.1 Flight Preparation Pairing the drone with the remote control 1. Turn on the power switch of 2. Push the power switch on the aircraft's body the remote control. to the "ON" position. 3. Push the left joystick (throttle) fully up and down. The indicators on the drone and remote will change from flashing to solid, indicating that the drone is in flight-standby mode.
Pre-flight preparation Method one Method two Method three Push the left joystick fully up Push the left and right joysticks Press the one key take-off/landing button. and return to the center. downward in a V shape for 2 seconds. The propeller will begin to rotate then the The propeller will begin to rotate.
3.2 Flight Control Ascend Descend Forward Backward The end with the red light is the front. rotate to rotate to the left the right Rear The end with the red light is the front. Fly to Fly to the left the right Rear...
3.3 Flight Mode Trimming The end with the red light is the front. Trimming forwards and backwards If the drone automatically moves forward/backward while hovering, during hovering you can adjust the movement by holding down the left joystick and push the right joystick to the opposite direction (backward/forward).
High/low speed modes Short press the right joystick to switch between high speed mode and low speed mode. 1. The default mode upon powering on is slow speed mode. 2. The remote controller emits two "beeps" for high-speed mode and one "beep" for low-speed mode. 3.4 Smart Flight Feature front/back or left/right rolling (The end with the red light is the front) The end with the red light is the front...
Page 14
Spinning function (The end with the red light is the front) hold the spin button Right-handed spin Left-handed spin Hold the spin button on the remote control and push the right joystick to the left/right, the aircraft will spin in the corresponding direction. Rise at the same time press and hold the spin...
press and Right hold the rotate spinning button Left spinning Rotate one turn to the right Rotate one turn to the left Short press the rotate button on the reomte once and quickly hold it again and push the right joystick to the left/right, the aircraft will rotate around and draw a circle in the air while it's spinning.
Altitude hold When releasing the left joystick (throttle) after controlling the drone to ascend/descend, the drone will continue to hover at the current height. 3.5 Product Feature Undervoltage protection When the two indicators on the rear of the drone start to flash, it means that the power of the drone is low.
4.0 Troubleshooting Problem Cause Solution 1. Correctly bind the frequency between After the drone and 1. The drone and the remote control the drone and remote control. The remote is powered are not bound with each other. indicator light keeps on when there is a on, the drone fail to 2.
5.0 Contact Us Please do not hesitate to contact us if you need any further support. warranty@symatoys.com.cn +1 718-312-0558(US) +44 (0)7723708421(UK) +4933545519201(DE) For online support, please scan this code with Facebook Messenger 6.0 Product Accessories Blade Motor Battery Remote control USB Charging Cable...
Page 20
Transmitter power: 10dBm Product name: [Drone] Decoration of Conformity Inserts: Hereby, GuangDong SYMA Model Aircraft Industrial Co., Ltd. declares that the radio equipment type helicopter is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:...
2 YEAR WARRANTY: LIMITED 2-YEAR WARRANTY AND FREE LIMITED REPLACEMENT PARTS FOR 2-YEARS Symatoys.com.cn warrants to the original buyer only that its products will be free from defects in material and workmanship for 2 years from the date upon which the product is shipped, either directly from symatoys.com.cn or from an Authorized Re-seller’s location, to the buyer.
Page 22
LIMITED REMEDY: Symatoys.com.cn's sole liability, and buyer's sole remedy for any breach of the foregoing warranty shall be at Symatoys.com.cn's option to exchange the product with a new product or a refurbished product that is functionally equivalent to the original product, or issue a credit or refund to the purchase price the product.
Page 23
Duvin Trade Inc 5800 Wood Sorrel Dr,Littleton,Co, 80123,United States Phone: 718-312-0558 E-mail: usa@symatoys.com Manufacturer: GUANGDONG SYMA MODEL AIRCRAFT INDUSTRIAL CO., LTD Address: NO.2 WEST XINGYE ROAD LAIMEI INDUSTRIAL AREA CHENG HAI , Shantou, China Postal Code: 515800 +1 718-312-0558 +44(0)7723708421(UK) +49 335-4551-9201(DE) usa@symatoys.com(US) eu@symatoys.com(EU)
Page 24
REMOTE CONTROL DRONE Take-off/landing Flip stunts 6 Axis gyroscope Flashing LED 2.4 GHz frequency Hover function lights...
Need help?
Do you have a question about the X660 and is the answer not in the manual?
Questions and answers