Honeywell 7900L0P-422C20E - Hand Held Products Dolphin 7900 User Manual page 189

3. Secure the DIN Rail to a stable, flat horizontal surface.
Using the Mounting Brackets
A wall mount kit can be purchased separately. It contains two mounting brackets to secure both ends of the ChargeBase. Use
the screws and the mounting brackets to mount the ChargeBase to a wall or other vertical surface. Each mounting bracket
contains an open slot in the back to accommodate the connector cables.
The bottom panel of the ChargeBase contains rubber feet that hold it steady on a flat surface. We recommend that those rubber
feet be removed with pliers prior to applying the mounting brackets to the bottom panel.
1. Secure the screws into the four screw slots on the bottom panel. Insert the heads into the round end and slide towards the
narrow end until the screw is secure.
2. Attach the bottom panel to the two mounting brackets.
Dolphin® 7900 User's Guide
Washer/nut sets and
screws in slots
Rev F
10/16/07
14 - 5