Ram Mounts No-Drill RAM-VB-195 Manual

Specifications
Placement
Passenger side, in front, where seat frame meets floor board
Seat Configuration
Bucket or 40/20/40 split bench
Construction/Finish
Steel/Black powder coat
Dimensions
(A) 14.875" (B) 7" (C) 2"
(Hole Center) 13.625"
Pole or Pedestal
Ordered separately
Drilling Required
None - uses existing seat bolts
Features
Installs in minutes with no drilling required. Placement is over the top of the seat frame legs at floor
board level. Rock solid construction backed by a lifetime warranty. Though not necessary for all
applications, kit comes with additional stabilizer foot to help support heavier devices.
Installation Instructions
Please read through the installation instructions entirely before beginning the installation of this product.
Depending on your make and model, there may be pieces of plastic trim that cover the lower front of the seat frame legs. This will need to be removed and
stored. In some Ford models, under the plastic trim cover is a small Allen head screw. Remove this to allow the plastic trim to accommodate the drill base.
Move the passenger side seat to its rearmost position.
1
Using the appropriate socket, loosen and remove the two bolts holding the seat frame legs to the floor board.
2
Gently lift the front of the seat upward to create a 1/4 inch gap under the seat frame legs.
3
Slide the RAM No-Drill™ base under the seat frame legs with the pedestal platform near the center of the vehicle and align the holes of the seat legs,
®
4
no drill base, and threaded holes in the floor plan.
Re-install the two seat frame bolts. Start the thread by hand and then fully tighten with the socket wrench.
5
Though not necessary for all applications, this base comes with a stabilizer foot. Use this in the place of one of the carriage bolts that secure the lower
6
female pole to the no drill base. This foot should be adjusted so that it touches off on the floor pan and supports the overhang of the base.
Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver's vision or interferes with vehicle
operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.
To see more mounting options, visit rammount.com
rammount.com
1.800.497.7479
support@rammount.com
C
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM No-Drill
® ™
A
Seat Base
RAM-VB-195
B
RMR-INS-VB-195