Ram Mounts Quick-Grip RAM-B-149Z-A-UN15WU Quick Installation Instructions

Part Index
*not to scale
A B C
x1 x1 x1
Connect (B) Puck Slide to (A) RAM
1
and (D) Ratchet Washers. Do not fully tighten yet.
B
Shift Apple MagSafe cable up and down until magnets are properly
3
aligned with phone. Once aligned, fully tighten (E) Screws on the back.
Hand-tighten only, do not over-tighten.
Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver's vision or interferes with vehicle
operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.
To see more mounting options, visit RamMount.com
rammount.com
1.800.497.7479
support@rammount.com
D E F
x2 x2 x2
(#6 X ½") (#8-32) (#8-32 X ½")
Quick-Grip Holder, using (E) Screws
® ™
A
D
E
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
G H I
x2 x2 x2
(#8-32 X 5/8") (#8-32 x 3/4")
Insert Apple MagSafe into (B) Puck Slide, followed by phone.
2
RAM Quick-Grip
®
Holder for Apple MagSafe
Not Included
J K
Apple MagSafe
x2 x1
™
RMR-INS-461
1