Ram Mounts Tough-Tray Quick Start Manual

Parts Index
not to scale
A x 1
B x 1
C x 1
Thread (G) nut onto (A) rod with 3/8" of the rod protruding.
1
G
Pull the Main Tray Slide out and attach (E) flange using (J) screws and (I) nuts.
3
RAM logo must face upright.
®
E
J
Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver's vision or interferes with vehicle
operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.
To see more mounting options, visit rammount.com
rammount.com
1.800.497.7479
support@rammount.com
J
x 4
#8-32 x 1/2"
2
A
I
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
RAM
E F
x 1 x 2
L
K
x 1 x 1
#8-32 x 3/8" #8-32 x 1 1/2"
Slide (F), (N) and (C) onto rod as shown below.
G A
Locate and remove screw on the tray housing supporting
4
the spring.
Tough-Tray Locking Kit
® ™
G H
x 1 x 1
1/4"-20 #8-32
N
M
O
x 1 x 2 x 1
1/4" #12 #8
N
F
Continue on back
I
x 4
#8-32
P
x 1
C