Universal Remote Control MX-350 - SPECS SHEET Owner's Manual page 7

T h e M X - 3 5 0
4 The display will show a list of the first five devices.
Select the device you would like to teach commands to by pressing
5
the Device button.
6 Now, press any button you want to teach a command to.
Note: If you don't see the display button you would like to teach, use the
PAGE buttons. The only buttons you can't teach are the PAGE and MAIN but-
tons.
Once you press a button, the top of the display will change from
"LEARN" to "READY".
10
Press any
of the
Device
Buttons.
Press
any
Button.
U n i v e r s a l R e m o t e C o n t r o l , I n c .
Press and hold the button you want on your old remote control until
7
the display changes to either "GOOD" or "FAILED".
If the "GOOD" label appears on top of the display, you were successful.
Now, press the next button you wish to teach. Keep repeating steps 6
through 7 until you have learned all the buttons you want.
If the "FAILED" label appears on top of the display, try to teach the
same button in MX-350 once again by repeating steps 6-7.
Continue to teach any commands from any of your remote controls
8
by repeating steps 5-7 (to go back to step five, press MAIN once).
Once you completed teaching all the buttons, return to normal opera-
9
tion by pressing the MAIN button twice. Test all your new commands.
If any of them don't work, try learning again using these notes:
Move to another room. Plasma TVs, sunlight, halogen or
quartz lighting can interfere with the learning process.
Although the old remote control seems to work fine,
change the batteries to fresh alkaline batteries.
Vary the distance between the remote controls
gradually. Try 1/4", 1", 2"and so on, up to 4 feet.
Tap the button on the original remote control instead of
pressing and holding it during the learning process.
11