Universal Remote Control AVEX R6 - SPECS SHEET Owner's Manual page 15

IMPORTANT: You have 30 seconds to perform the
next step while you are in programming mode. If
you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 2: Press the component button you want to
turn on and then the POWER button; repeat for all
other components in the order you want them to turn
on. The component LED lights will blink once each
time you press the P OWER button.
COMPONENT
BUTTONS
STEP 3: Once you've entered all the Power On
commands, press the CHANNEL UP
your MacroPower commands. The component LED
lights will blink three times to confirm that the
programming has been successfully saved.
SUGGESTION: Most of the components have the
same signal to turn the power On and Off. You may
want to program MacroPower only in the POWER
button and save the System Off button to turn
components On or Off individually.
Note: If you want to program MacroPower for the
SYSTEM OFF button, repeat the same steps used for
Power ON programming.
POWER
Page 15
button to save
CHANNEL
UP