Braun 5 Series, 510 Manual

Description

Your shaver is provided with a special cord set, which has an integrated Safety Extra Low Voltage power supply. Do not exchange or tamper with any part of it, otherwise there is risk of electric shock.

1. Shaver foil
2. Cutter block
3. Foil release buttons
4. Long hair trimmer
5. Comfort setting switch «sensitive»
6. On/off switch
7. Shaver power socket
8. Special cord set
9. Etui

Shaving

Press the on/off switch (6) to operate the shaver.

Comfort setting switch «sensitive»
Setting the shaver head according to your comfort needs.

The «sensitive» switch (5) provides three options for comfort setting:

1. « + »:
   The shaver head is in full swing, freely follows the contours of your skin to provide more comfort.
2. middle position:
   The shaver head is semi-fixed for more control.
3. « – »:
   The shaver head is fixed for full control and precise handling in hard to reach areas.

Long hair trimmer
To trim sideburns, moustache or beard, slide the long hair trimmer (4) upwards.

Cleaning

The shaver head is suitable for cleaning under running tap water. Warning: Detach the shaver from the power supply before cleaning the shaver head in water.

Regular cleaning ensures better shaving performance. Rinsing the shaving head under running water after each shave is an easy and fast way to keep it clean (A):

• Rinse the shaver head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam.
• Next, press the foil release buttons (3) to remove the shaver foil (1) and cutter block (2). Then leave the disassembled shaving parts to dry.
• If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer and shaver foil.

The following quick cleaning is another alternative cleaning method (B):

• Press the foil release buttons (3) to lift the shaver foil (do not remove the foil completely). Switch on the shaver for approx. 5–10 seconds so that the shaved stubbles can fall out.

• Switch off the shaver. Remove the shaver foil and tap it out on a flat surface. Using the brush, clean the inner area of the shaver head. However, do not clean the shaver foil nor the cutter block with the brush as this will damage them.

Keeping your shaver in top shape

Replacing the shaver foil and cutter block
To maintain 100% shaving performance, replace the shaver foil (1) and cutter block (2) at least every 18 months or when worn.

Change both parts at the same time for a closer shave with less skin irritation.

Accessories
Available at your dealer or Braun Service Centres:
Shaver foil and cutter block: 51S

Subject to change without notice.