Door Control - Chamberlain 8360 Manual

Door Control

TIMER-TO-CLOSE (TTC)
(881LM ONLY)
NOTE: DO NOT enable TTC if operating a
one-piece door. TTC is to be used ONLY
sectional doors.
Activate:
Press and hold the ON button until one of the
TTC LEDs light up. Then press the ON button
again to cycle through the time interval options
(the corresponding TTC LED will light for each
time interval). The garage door opener light
bulbs will blink as confirmation.
Deactivate:
Press and hold the OFF button until all TTC
LEDs turn off and a beep is heard from the
motor unit.
Temporarily hold door open (suspend TTC):
Press and release the HOLD OPEN button.
Press the HOLD OPEN button again to resume
normal TTC operation.
ON Button
1 Minute
TTC LED
OFF Button
5 Minute
TTC LED
HOLD OPEN
10 Minute
Button
TTC LED
LOCK LIGHT
Activate: To change the amount of time the garage door opener lights will stay on:
Press and hold the LOCK button Press and hold the LOCK button until the garage door opener lights flash.*
for 2 seconds. The command The time interval is indicated by the number of flashes.
LED will flash as long as the lock
feature is activated and your
handheld remote control will not
operate your garage door at this
time.
Deactivate:
Press and hold the LOCK button
again for 2 seconds. The
command LED will stop flashing
and normal operation will resume.
To cycle through the time interval repeat the step above.
LIGHT FEATURE
Deactivate:
Command LED
Press and hold the LIGHT button until the garage door opener lights turn
on, then off again.*
Activate:
Start with the garage door opener lights on. Press and hold the LIGHT
LOCK Button
button until the garage door opener lights turn off, then on again.*
NOTE: If the command LED is continuously blinking, the LOCK feature
needs to be deactivated.
Number of times garage door Times the garage door opener light
opener lights flash
1
2
3
4
Command LED
LOCK Button
* Approximately
LIGHT Button
10 seconds
31
MOTION SENSOR
Activate/Deactivate:
Slide the motion sensor switch ON or OFF.
Motion Sensor
Switch
stays on
1 1/2 Minutes
2 1/2 Minutes
3 1/2 Minutes
4 1/2 Minutes
MAINTENANCE ALERT
SYSTEM (MAS):
Activate/Deactivate
Press and hold the LEARN button. Then
press the LIGHT button. The service
LED will flash the status; Active is 2 flashes
and deactivated is 3 flashes.
Service LED
LEARN Button
LIGHT Button
Motion
Sensor