Giant HYBRID CYCLING Owner's Manual page 5

step 4
Lift the EnergyPak pack out of its holder.
step 5
Place the EnergyPak in a horizontal
position and then insert the charger plug
into the EnergyPak's charging socket.
step 6
Connect the power source plug into a
grounded electric outlet (AC 110-240 volts)
and make sure that all poles are fully inserted
into the socket. NOTE: Some Hybrid
bicycles are equipped with a "Euro-style"
power source plug. First insert that plug
into the supplied adapter. Then insert the
adapter into a grounded electric outlet (AC
110-240 volts).
caution
KEEP THE AREA WHERE THE ENERGYPAK IS
CHARGED WELL-VENTILATED AND FREE
FROM LITTER OR ANYTHING ELSE COMBUSTIBLE
TO AVOID FIRE FROM SPARKS OR OVERHEATING!!
step 7
Confirm that LED lamp of the charger
lights up red. The light should remain
constant and not flash. When charging is
finished (which could take approximately
6 hours) the light will go out. The
EnergyPak is fully charged.
caution
DO NOT CHARGE ENERGYPAK(S) FOR MORE
THAN 24 HOURS!!
step 8
Disconnect the EnergyPak from the charger after the charge is
completed. Unplug the charger's power source plug from the
electrical outlet.
7
step 9
Mount the EnergyPak into its holder.
Step A
Slide the EnergyPak pack into its holder at a
45-degree angle. Make sure the "GIANT"
logo on the EnergyPak is facing the outside
of the bicycle.
Step B
Replace the handle. Gently pivot the
EnergyPak to an upright position until
the EnergyPak snaps into place. If the
EnergyPak does not pivot easily, remove it
and reposition it in the holder and try again.
step 10
Make sure that the EnergyPak is secured
in the "LOCK" position, so that it cannot
move from side to side.
Step A
Giant
logo
Step B
Handle
8