Folding Instructions - Giant HALFWAY BIKES-2001 Owner's Manual

2.1

Folding instructions

6 Steps.
In order to allow the folding bike to stand upon the ground properly after folding, please perform the following
first:
1. Set the kickstand to the parking position.
2. Adjust the seat post to its lowest possible position.
3.
Crank position should be adjusted as shown below (fig. 5).
Step 1 Loosen the seat binder (quick release) and push the saddle almost to the bottom. Then tighten the
quick release again.
Step 2 Rotate the knob of the handlebar stem in an anti-clockwise direction.
After release, the stem can be folded downward.
Click the upper part into the plastic holder on the frame.
Step 3 Grab the frame with both hands and loosen the frame release.
Step 4 Fold the frame.
Step 5 Pedal folding: turn to the backside of the pedal, then you can fold it by rotating the switch 90 degrees .
Step 6 Place the bike inside the travel bag.
Refer to the pictures below for an illustrated example of folding the bike.
Unfolding is the reverse procedure.
Make sure all releases for frame, seat post and handlebar stem are fixed.
Refer to chapter 3 and 4.
IMPORTANT NOTES.
Figure 4 and 6: these pictures show another type of handlebar stem than the one that is used on Halfway
bicycles !
The frame quick release (fig. 3) has an adjustment nut that controls the clamping force of the quick release and
the force that is needed to open/close this quick release.
MAKE SURE THAT THE FUNCTION OF THE QUICK RELEASE AND THE ADJUSTMENT NUT ARE
DEMONSTRATED BY THE BICYCLE DEALER BEFORE USING THE BIKE.
4
.
1
5
2
6
2
3
INDEX
TOP