Folding Pedal; Carrier - Giant HALFWAY BIKES-2001 Owner's Manual

6.5 Folding pedal.

This pedal is of a foldable design, so you can reduce the
profile of the bike when folded.
Turn to the underside of the pedal (see fig. H-1).
Rotate the controlling switch to 90 degrees to loosen the
stopper, then you can fold it (see fig H-2).
NOTE:
This pedal is used only for single side usage, please
make sure your feet are on the flat side of the pedal
while cycling.
When putting the pedal back to the riding position, make
sure the controlling switch is in the locked position.

6.6 Carrier.

How to adjust the carrier.
1. There are two sets of bolts on the carrier
(see fig. I-1 & I-2). One is fixed on the frame
(Bolt A); the other is fixed on the beam and top plate
(Bolt B).
2. If you want to move the top plate on the carrier, just
loosen Bolt B, the top plate can be moved on the
beam, tighten the bolt after adjusting it to a proper
position.
3. You can use a 5 mm Allen Key to loosen Bolt A,
then you can remove the carrier.
How to take full advantage of the versatility of the carrier:
If you have flat articles to carry, just pull up the lever
on the top plate, then fix the article by binding the
elastic tape to the rail of the top plate (see fig. J-1).
If you have rectangular articles to carry, use the
same way as mentioned above to fix it, but adjusting
the position slightly (see fig. J-2).
How to adjust the position when folding.
In order to prevent any rubbing when folding the frame,
please refer to Section: How to adjust the carrier.
Then adjust the top plate to the proper position
(see fig. K-1 & K-2).
NOTE:
The carrier has a max. load capacity of 10 Kg.
Do not overload the carrier.
Fig. H-1
Foldable pedal
Fig. H-2
INDEX
Foldable pedal
Fig. I-1
Fig. I-2
10
Top plate bolt (B)
Carrier bolt (A)