Advertisement
Quick Links
Advertisement
Related Manuals for GreenWorks ST40B410
Summary of Contents for GreenWorks ST40B410
- Page 1 ST40B410 OPERATOR MANUAL STRING TRIMMER 2101602/2101602A STF305 www.greenworkstools.com...
- Page 3 English Start the machine........9 Description........4 Stop the machine........9 Purpose............4 Adjust the length of the cutting line.... 9 Overview............ 4 Adjust the length of the cutting line Important safety instructions..4 manually............. 9 Symbols on the machine.... 5 Operation tips..........
- Page 4 English glasses have only impact resistant lenses. They are DESCRIPTION NOT safety glasses. Following this rule will reduce the risk of eye injury. Use face mask if operating in PURPOSE dusty workspaces. • Avoid Dangerous Environment – Don’t expose This machine is used to cut grass, light weeds, and power tools to damp or wet conditions.
- Page 5 Use only with the nylon cutting line of 0.065" packs. Use of any other battery packs may create (1.65 mm) diameter. Do not use heavier lines a risk of injury and fire. Use only with Greenworks than recommended by the manufacturer and line 29462/2901319/29472/BAF724 battery or other BAF materials of other types –...
- Page 6 English Symbol Explanation SYM- SIGNAL MEANING Voltage CAUTION (Without Safety Alert Sym- Current bol) Indicates a situation that may result in property Frequency (cycles per second) damage. Power Time SERVICE Revolutions, strokes, surface speed, /min Servicing requires extreme care and knowledge and orbits etc., per minute must be performed only by a qualified service Direct current...
- Page 7 English WARNING WARNING If the battery pack cracks or breaks, with or without • If parts of the machine are damaged, do not use leaks, do not recharge it and do not use. Discard it the machine. and replace with a new battery pack. DO NOT TRY •...
- Page 8 English 4. Tighten the auxiliary handle with the knob (3). ASSEMBLE THE SHAFT 1. Loosen the screw (1) on the coupler (2). OPERATION IMPORTANT 2. Push in the release button on the lower shaft (5). Before you operate the machine, read and understand the safety regulations and the operation instructions.
- Page 9 English START THE MACHINE 1. Push the lock-out button (1) and pull the trigger (2). Once the machine is running you can release the lock-out button. OPERATION TIPS WARNING Keep clearance between the body and the machine. WARNING STOP THE MACHINE Do not operate the machine without guard in place.
- Page 10 English • Stop the machine. • Remove the battery pack. • Cool the motor. • Store the machine in a cool and dry place. DANGEROUS CUTTING AREA • Use correct clothing, protective gloves and safety glasses. 10.2 CLEAN THE MACHINE •...
- Page 11 English NOTE Make sure that you put the cutting line in the slot on the new spool and extend the line approximately 15 cm before you install the new spool. 5. Put the ends of the cutting lines through the holes. 5.
- Page 12 English Problem Possible Cause Solution TROUBLESHOOTING The battery pack Charge the battery is depleted. pack. Problem Possible Cause Solution The line Lines are welded Lubricate with silicone The ma- No electrical 1. Remove battery does not to themselves. spray. chine does contact between pack.
- Page 13 Charger operation temper- 39°F (4°C) - 104°F (40°C) requested in writing by Greenworks. ature range USA address: Battery storage tempera- 32°F (0°C) - 113°F (45°C)
- Page 14 www.greenworkstools.com Rev B1...
Need help?
Do you have a question about the ST40B410 and is the answer not in the manual?
Questions and answers