Chapter 4 Macro Function - Delta Electronics A10 User Manual

Macro function provides various commands. When the HMI user works with macro commands on the HMI, it
can reduce the PLC program editing efficiently. Therefore, Macro is a very convenient function for the HMI
user to use. After editing Macro, the user can test the Macro validity via either on-line simulation or off-line
simulation on the PC before downloading to HMI. The lines number for each macro is 512 lines and 128
words (max.) for writing comments or strings in a line. The sub-macro number is 512 sub-macros (number is
1-512). See Fig. 4.1 and Fig. 4.2.
Revision Apr. 30th, 2007, 2007PDD23000002

Chapter 4 Macro Function

Fig. 4.1
The user can comment each macro by sub-macro
function for the convenience of management,
maintain and operation. The initial name of all sub-
macro is Sub-macro (n) (n is from 1 to 512).
Fig. 4.2
The left-most field in the left window is sub-macro
number. There are max. 512 sub-macros for editing.
The user can use call command and write "CALL n"
(n is from 1 to 512) to use sub-macro.
4-1