Advertisement
Quick Links
Installation, Operating and Maintenance Instructions
Kair Centrex Inline MEV
Product Models: CX125T, CX125HT, CX204T, CX204HT
• Continuous
Mechanical Extract Ventilation Unit (MEV)
• Efficient, low energy solution to controlling condensation and pollution in
residential properties up to 185m
• Variable choice of low (trickle), boost and purge speed at installation
• For Ceiling, loft or void installation
• Compact, ultra low profile unit
• Requires only one discharge grille
• Cost saving compared to multi-spigot installation
• Complies with Building ADF (System 3)
2
Kair Centrex Range |
www.kair.co.uk
Data sheets & Product Information
Scan this QR code with your phone to
view more information about this fan.
Page 1
| hello@kair.co.uk
Advertisement
Related Manuals for Kair Centrex Inline MEV CX125T
Summary of Contents for Kair Centrex Inline MEV CX125T
- Page 1 Installation, Operating and Maintenance Instructions Kair Centrex Inline MEV Product Models: CX125T, CX125HT, CX204T, CX204HT • Continuous Mechanical Extract Ventilation Unit (MEV) • Efficient, low energy solution to controlling condensation and pollution in residential properties up to 185m • Variable choice of low (trickle), boost and purge speed at installation •...
- Page 2 6. Do not place the unit or any part of it in water or liquids, except as indicated in the cleaning and maintenance section. 7. When cleaning or performing routine maintenance, check the condition of the appliance. Page 2 Kair Centrex Range | www.kair.co.uk | hello@kair.co.uk...
-
Page 3: Operation
(*PIRFF, DRH240 and THM may have integral over-run timer which controls the length of time that the fan will continue to operate at its boost speed after the boost has been switched off) Page 3 Kair Centrex Range | www.kair.co.uk | hello@kair.co.uk... - Page 4 Centrex – Installation DIMENSIONS – CX125 DIMENSIONS – CX204 Page 4 Kair Centrex Range | www.kair.co.uk | hello@kair.co.uk...
-
Page 5: Cleaning And Maintenance
Rotate slightly and remove the motor-impeller assembly (Fig. 8). • Clean the motor-impeller assembly either with a dry brush or a dry cloth. • Electrical parts cannot be cleaned. • Reassemble in the reverse order to above (Fig 9). Page 5 Kair Centrex Range | www.kair.co.uk | hello@kair.co.uk... - Page 6 N.B For all other commissioning (including Humidistat on "H" models), the jumper should be in the factory default position - i.e POSITION 2 Kair Ventilation Ltd, 9a High Street, Sidcup, Kent, DA14 6EN www.kair.co.uk | hello@kair.co.uk 020 8463 9695 Ver 1.01. 20220805...
Need help?
Do you have a question about the Centrex Inline MEV CX125T and is the answer not in the manual?
Questions and answers