General Safety Instructions for Power Tools 1. Know Your Power Tool 11. Wear Proper Apparel Read and understand the owner’s No loose clothing, gloves, neckties or manual and labels affixed to the tool. jewelry (rings, wristwatches), to get Learn its application and limitations caught in moving parts.
Page 3
6. Screw on the locknut (3) received with workpiece from shifting. the hold down and tighten it against If your RIDGID miter gauge has a small the bar using a 1/2 inch wrench. setscrew located in the head of the miter 7.
Directions “B” NOTE: The small knob (8) on the clamp screw must not turn on the threaded rod. 1. Turn the miter gauge lock handle coun- Check the nut underneath it. It must be terclockwise and remove the lock han- tight against the knob.
1. Loosen both wing screws. CAUTION: For your protection, never use miter gauge with clamp lock 2. Slide the clamp assembly to desired latch disengaged. The clamp pres- position. sure could release unexpectedly. 3. Tighten both wing screws. To change the miter gauge angle, the Clamp Lock wing screw located above the handle Latch...
Need help?
Do you have a question about the AC1022 and is the answer not in the manual?
Questions and answers