Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for PITSID GAP CONTROL
Summary of Contents for PITSID GAP CONTROL
- Page 1 INCREASE EFFICIENCY Operation Manual GAP CONTROL Smart Feeler Gauge for Measuring Gap Widths PITSID Polygraphische innovative Technik Leipzig GmbH Mommsenstraße 2 | D-04329 Leipzig Tel +49 341 25942-0 | Fax +49 341 25942-99 info@pitsidleipzig.com | www.pitsidleipzig.com...
-
Page 2: Table Of Contents
Index General Information 1.1 Symbols 2 Intended Use and Restrictions 3 Safety Instructions 4 Technical Data 5 The Measuring Device 5.1 Scope of Delivery 5.2 Storage and Transport 5.3 Device Configuration 5.4 Control Elements and Connections 5.5 Operating Principle 6 Measurement 6.1 Measurement Preparation 6.2 Measurement 6.3 Measurement Accuracy Information... -
Page 3: General Information 5 De
General Information These operating instructions will help you to set up, operate and maintain the Gap Guage GAP CONTROL. It contains important instructions that must be observed to ensure safe use. Familia- rise yourself carefully with this document before using the measuring device in order to avoid personal injury and material damage. -
Page 4: Intended Use And Restrictions
IMPORTANT must be deactivated or not started up. If necessary, secure the device The Gap Gauge GAP CONTROL was developed to carry out distance measurements against unintentional start-up! between hard/hard paired cylinders (or rollers) in printing presses. It may also be necessary to determine distances between cylinders on any other machine. -
Page 5: The Measuring Device
Measuring Wedges 5.2 Storage and Transport The device must be stored free from dust and moisture ( Chap. 3 Safety Instruc- Measurement range tions). For safe and practical transport, the device case included in the scope of Standard measuring wedge 1 1.800 mm …... -
Page 6: Control Elements And Connections
Switching the device on or off, ON / Off button Hold the GAP CONTROL in your hand or fix the hand-held device to a suitable surface Exiting a selected submenu directly on the machine using the built-in magnet on the back of the device. -
Page 7: Measurement Accuracy Information
Adding Additional Measuring Wedges The display gap width ---- while in the measuring position indicates a measured value outside the measurement range of the Before using additional measuring wedges, they must be initialized on the hand- measuring wedge. held device. Each measuring wedge has its own set of calibration data. You will find these in the documents of your measuring wedge. -
Page 8: Maintenance
Wedge-No: XXX/UU. Check the displayed wedge number with the The GAP CONTROL requires very little maintenance. Nevertheless, regular main- wedge number of the measuring wedge XXX/UU to be initialised. tenance of the measuring device is recommended. The maintenance mainly consists ▬... -
Page 9: Repair, Service
Compliance with the following harmonized standards is confi rmed: EN 61326-1:2013: Electrical measuring, control, regulating and laboratory devices – The GAP CONTROL hand-held measuring device must be disposed of EMC requirements - Part 1: General requirements as electronic waste in accordance with applicable laws. PITSID... -
Page 10: Warranty
The warranty claim expires if changes to the product by the customer or by third parties are not agreed upon with PITSID – Polygraphische Innovative Technik Leipzig GmbH and go beyond the activities described in this operation manual. This also applies to repair measures carried out independently or carried out by third parties.
Need help?
Do you have a question about the GAP CONTROL and is the answer not in the manual?
Questions and answers