Black & Decker 98010/91-005 Instructions

////±
BLACK & DECKER
"
INSTRUCTIONS FOR
No. 98010/91-005 FAST CHARGER
No. 98003/91-009 FAST CHARGE POWER PACK
IMPORTANT CHARGING NOTES
1. Longest life and best performance can be obtained if the batteries are
charged when the air temperature is about +75°F. DO NOT charge the
batteries in an air temperature below +40°F. or above + 105°F. This is
important and will prevent serious damage to the batteries.
2. When you charge your power pack for the first time, or after prolonged
storage, it will only accept about an 80% charge. However, after several
charge and discharge cycles, the batteries will be up to full capacity.
3. While charging, the Charger may hum and become warm to touch. This is
a normal condition, and does not indicate a problem.
4. If the batteries do not charge properly—(1) Check current at receptacle
by plugging in a lamp or other appliance, (2) Check to see if receptacle is
connected to a light switch which turns power off when you turn out the
lights. (3) Move charger and power pack to a surrounding air temperature
of approximately +75^. In an extremely warnTenvironment the power paCk~
may be too hot to permit fast charging. (4) If the receptacle and temperature
are o.k., and you do not get proper charging, take or send the tool and
charger to your local service center. See 'TOOLS, ELECTRIC" in yellow pages.
5. The power pack should be recharged when it fails to produce sufficient
power on jobs which were easily done previously. DO NOT CONTINUE to
use under these conditions. Repeat the charging procedure.
6. If, after repeated use, your power pack does not take a full charge, and
produces operating time less than normal, it may not be caused by faulty
batteries. If you use the power pack repeatedly for only a few minutes and
then charge it, the batteries build up a resistance to taking a full charge.
This resistance results in reduced operating time.
The batteries can be restored to their original power and life by fully
charging and then completely using up the charge several times. This will
recondition the batteries to deliver maximum performance.
7.
This Charger and Power
Pack
are specifically designed to work together.
DO NOT attempt to charge any other cordless tool or battery pack with
this Charger.
8. Avoid dangerous environment. Don't use charger in damp or wet locations.
9. The charger is designed to operate on standard household electrical power
(120 volts). Do not attempt to use it on any other voltage!
10. Don't abuse cord. Never carry charger by cord or yank it to disconnect.
Keep cprd from heat, oil and sharp edges.
Turn Over For CHARGING PROCEDURE