Related Manuals for Klima MIC2
Summary of Contents for Klima MIC2
- Page 1 MIC2 Digital Thermostat Klima Underfloor Heating Karelia House, Keltneyburn By Aberfeldy, PH15 2LS T 01887 822020 technical@klima.co.uk W www.klima.co.uk...
- Page 2 1) User Manual INDEX Getting Started with the MIC 2 Digital 1) User Manual Buttons: 1A) Getting Started with the MIC 2 Digital 1B) Start Up Wizard 1C) Mode (Thermostat Operating Functions) 1D) Menu (Thermostat settings) 2) General Information Left hand button 2A) Explanation of LED Colours/Signals functions Right hand button...
- Page 3 1. Thank you: 7.Temperature Control: -The right-hand button as this message is just to say thank for using our -Floor temp or room temp, if you selected yes for floor sensor then select floor product temp. (If room temp is selected you will go straight to point 2.Measurement Choice: 8.
- Page 4 1C) Mode (Thermostat Operating Functions) 1D) Menu (Thermostat settings) 1.Automatic: 1.Temperature settings: - The thermostat will switch on according to the programmed, this will depend With this function you can change the programmed temperature on if the thermostat is set to standard program or custom program. (comfort or setback temperature) 2.Temporary: -This will temporarily override the temperature in the automatic program, the...
-
Page 5: Advanced Functions
-Contrast: Allows you to change the colour difference on the screen of the colour Pilot wire: It is used to operate the thermostat through an external source i.e. home management system. This can be turned on or off. -Brightness: Allows you to make the screen brighter or dimmer when in use Sensor Type: Used to change the sensor value, the default is 12K ohms and -Backlight Delay: How long the screen will remain lit after a button has been pressed does not need to be changed in a standard situation. -
Page 6: Intelligent Function
Sensor error / fault: 2G) Energy consumption: Sensor may be wired incorrectly or loosely. Heating system will not work when The energy consumption depends on a lot factors. The important factors are there is a sensor fault. The red LED Will flash. individual preference (which temperature you feel is comfortable), insulation, We recommend you check the wiring of the floor sensor and tighten the settings of the thermostat, humidity in the room, separate rooms, location, etc. -
Page 7: Technical Support
01887 822020 or send us an email to Before installation or re-installation of the thermostat always isolate the power Technical@klima.co.uk to the thermostat. Installation needs to be done by a qualified electrician in accordance with all current wiring and building regulations. The MIC 2 Digital... - Page 8 7) Press the DOWN ARROW once and “Custom” will be in the middle of the screen and 2) When “Sunday” has been programmed, you should be in the part where “Weekday” push the RIGHT-HAND BUTTON once and then press the UP ARROW once. is at the top of the screen, press the RIGHT-HAND BUTTON once when “Sunday”...
Need help?
Do you have a question about the MIC2 and is the answer not in the manual?
Questions and answers