Hyundai R6F37 AC000 Manual

Copy OEM Logo Here (→)
Electronic Installation Instructions
If this is a printed copy of the installation instructions, ensure you have the latest revision by
scanning the QR code or by entering the website address listed below before beginning
installation. Use the latest revision date as noted by "Rev. Date" above.
www.hyundaiaccessories.com/admin_media_uploads/installationSheets/r6f37_ac000.pdf
Instructional Symbols / Definitions
Denotes warnings that may lead to
serious physical injury or vehicle damage
Denotes cautions to be taken to avoid
physical injury or electronic component
damage
Denotes cautions to be taken to avoid
vehicle and component damage
Basic Required Tools
#2 Phillips
#2 Phillips Socket
Screwdriver
Needle-Nose Pliers Utility Knife
Part Weight (Gross) FMVSS 110 Compliance Information
All dealers must determine if the Net weight they have added in the form of all options or accessories, when added to the weight of all Port/Dealer Installed
36.90
lbs
options or accessories, exceeds the lesser of 1.5% of GVWR or 100 lbs. If the additional weight does exceed the lesser of the indicated thresholds, a "Load
Carrying Capacity Reduced" label must be installed. A black, fine-point, indelible marker must be used to write by hand onto the label, the reduced carrying
16.74
kg capacity in kilograms or pounds, which is the total weight of all added options and accessories.
Load Label Part Number: NP070 - 09003
Notes to the installer:
1) Read the entire Installation Instructions prior to beginning the installation of this accessory.
2) If applicable, scan the barcode label located on the accessory part or packaging prior to installing, to register the part. If this accessory is installed as a replacement, register the removal
of the old part before registering the new part. Old and new parts will have different barcode data, and the old registration cannot be reused.
3) Make sure the vehicle is completely clean and dry in the area(s) the part is to be installed.
4) Ensure the vehicle is properly protected in the area(s) that the accessory is to be installed.
5) NEVER place tools on painted surfaces, seating surfaces, dash pad, console or floor carpet/mats.
6) Always wear appropriate personal protective equipment, including gloves, safety glasses, etc., when required.
7) Do NOT use a two-post vehicle lift for side step installation.
Genuine Accessories
Vehicle Model: Santa Fe
Model Year 2024~
Part No. R6F37 AC000
Language English
Rev. Date 3/8/2024
Denotes quality processes to be checked
prior to moving to the next step
Denotes specific tools that are necessary
to complete a step
N
O
Denotes important information to be
T
reviewed during the step
E
Plastic Trim
Extension
Removal Tool
50/50 Mix Of
Drop Cloth (Large) Isopropyl Alcohol
(70%) & Water
Revision Date
03/08/2024
Accessory: Side Steps
Difficulty: ( B )
Note: Difficulty stated above reflects the minimum level of
expertise required to install the accessory:
(A) Customer
(B) Dealer Technician
(C) Master Technician or Specialist
Denotes personal protective equipment (PPEs) that
may be required for a step. Examples of safety
equipment icons noted below:
Glasses
Mask
Clip Removal Tool Ratchet
Clean Towel 10mm Socket
Gloves
Hearing Protection
Torque Wrench
17mm Socket
Page 1 of 8