MaxLite PathMAX Series Operating Instructions Manual

Operating Instructions
MaxLite Slim Bollard Series
®
General Safety Information
WARNING:
• To reduce the risk of death, personal injury or property damage from fire, electric shock,
falling parts, cuts/abrasions, and other hazards read all warnings and instructions included
with and on the fixture box and all fixture labels.
• Before installing, servicing, or performing routine maintenance upon this equipment, follow
these general precautions.
• Commercial installation, service and maintenance of luminaires should be performed by a
qualified licensed electrician.
• For the installation: If you are unsure about the installation or maintenance of the
luminaires, consult a qualified licensed electrician and check your local electrical code.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or
other sharp objects.
• Do not make or alter any open holes in an enclosure of wiring or electrical components
during kit installation.
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• All wiring connections should be capped with UL approved wire connectors.
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing, servicing or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION:
RISK OF FIRE
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
• Risk of burn. Disconnect power and allow fixture to cool before changing bulb or handing fixture.
RISK OF FIRE, EXPLOSION AND ELECTRIC SHOCK
• This product should be installed, inspected, and maintained by a qualified electrician only, in accordance with the NEC
(National Electric Code) and all local codes.
• Turn off electrical power before inspection, installation or removal.
• Use only UL (or other NTRL) approved wire for input/output connections. Minimum size 18 AWG or 14 AWG for continuous runs.
• Make sure LEDs and drivers are cool to touch when performing maintenance. Make sure the supply voltage is the same as the
rated voltage of the luminaire.
• Do not install in a hazardous atmosphere, except where the ambient temperature does not exceed the rated operating
temperature of the fixture.
• Keep tightly closed when in operation
Models:
This instruction manual applies to the PathMAX Series Round - Dome & Flat Top Slim Bollards
© Copyright 2025. MaxLite, Inc. All Rights Reserved.
342 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com
PathMAX™ Series
Pictures are for illustration purposes
only. Your model may vary.
Page: 1
Version: 1.1 Revision: 03/11/25