MaxLite ML1E 2DAR Series Operating Instructions

Operating Instructions
MaxLite LED Torchiere
®

General Safety Information

• To reduce the risk of death, personal injury or property damage from fire,
electric shock, falling parts, cuts/abrasions, and other hazards read all warnings
and instructions included with and on the fixture box and all fixture labels.
• Before installing, servicing, or performing routine maintenance upon this
equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires should be
performed by a qualified licensed electrician.
• For Residential installation: If you are unsure about the installation or
maintenance of the luminaires, consult a qualified licensed electrician and
check your local electrical code.
• DO NOT INSTALL DAMAGED PRODUCT!
WARNING:
RISK OF ELECTRICAL SHOCK
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label
information.
• Make all electrical and grounded connections in accordance with the National
Electrical Code and any applicable local code requirements.
• To prevent electric shock, match wide blade of plug to wide slot.
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from
carton, installing, servicing or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
• Don't touch the lamp when in use.
• Always switch off the mains supply. 5-10 minutes later to replace the lamp after the
used lamp has cooled down.
ML1E Series
Models:
© Copyright 2020. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 973-244-7300 Fax: 973-244-7333 Email: info@maxlite.com
ML1Ezz2DARxxyy Series
Picture is for illustration purposes
only. Your model may vary.
Page: 1
REV: 08/11/20