Graham Field LUMEX TUB-GUARD 69623A Assembly And Operation Instructions

Tools required: an adjustable wrench
WARNING: Important! Read and understand these instructions before assembling or using the 69623A / 69663A
Tub-Guard® Bathtub Safety Rail. If you do not understand any part of these warnings, cautions, or instructions,
contact a healthcare professional for direction in the use of this product. If the Bathtub Safety Rail is not
properly assembled and adjusted, personal injury and damage to the Bathtub Safety Rail could result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT use substitute
parts. Use only Lumex replacement parts. Non-Lumex replacement parts could cause personal injury and
damage to the Tub-Guard® Bathtub Safety Rail.
WARNING: This product has a weight limit of 250 lb (113 kg), EVENLY DISTRIBUTED.
WARNING: This product is NOT recommended for use on fiberglass or plastic bathtubs.
GF Health Products, Inc. ("GF") assumes no responsibility for any damage or injury caused by improper installation
or use of this product.
INSTALLATION
WARNING: DO NOT overtighten Bathtub Safety Rail adjustment handle.
1. Locate section of bathtub wall where Bathtub Safety Rail is to be
mounted. The Bathtub Safety Rail should be mounted ONLY on the
straight — not curved — part of bathtub wall. Ensure the tub surface
where the Bathtub Safety Rail will be installed is smooth, clean,
and dry before installing the Bathtub Safety Rail. Remove any dust,
powder, or foreign particles.
2. Fold out the adjustment handle from the recess in Bathtub Safety
Rail body.
3. Loosen the adjustment handle by turning it counter-clockwise until
clamping mechanism is wide enough to fit over bathtub wall. Place
Bathtub Safety Rail down onto bathtub wall. Adjustment handle
should be outside the bathtub, and clamping mechanism inside
the bathtub. Ensure the Bathtub Safety Rail is fully seated before
tightening.
4. Tighten the adjustment handle by turning it clockwise until the
Bathtub Safety Rail is firmly in place on bathtub wall. DO NOT
overtighten the adjustment handle.
5. Once unit is firmly in place, fold down the adjustment handle until the
handle locks back into the recess in the Bathtub Safety Rail body.
6. To test mounting before use, apply a strong push and pull motion to
the Bathtub Safety Rail. If the Bathtub Safety Rail moves, reset it and
tighten it more.
WARNING: Ensure the Tub-Guard Bathtub Safety Rail is installed as described before use.
OPERATION
WARNING: Always ensure the Bathtub Safety Rail is secure before use.
WARNING: Hold the Bathtub Safety Rail firmly when entering or exiting the bathtub.
MAINTENANCE / CLEANING
WARNING: Check the Bathtub Safety Rail weekly for signs of damage or cracking. If damage or cracking of
any component of the Bathtub Safety Rail is found, DO NOT use the Bathtub Safety Rail. Contact your GF
authorized provider.
Inspect the Tub-Guard® Bathtub Safety Rail weekly and tighten it as needed to ensure proper installation.
To clean the Bathtub Safety Rail, wash it with soap and water or a mild detergent, then rinse. Ensure the Bathtub Safety
Rail is rinsed well before use.
LX_69623A-INS-LAB-RevD23
69623A / 69663A: TUB-GUARD® BATHTUB SAFETY RAIL
ASSEMBLY AND OPERATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE USE
www.grahamfield.com
C C
A A
B
69623A
A) adjustment handle
B) clamping mechanism (one side only shown)
C) safety rail body
Tub-Guard Bathtub Safety Rails
B
69663A
1