Connecting The Router - Cisco 881W - Integrated Services Router Wireless Hardware Installation Manual

Connecting the Router

This chapter describes how to connect Cisco 860 series, Cisco 880 series, and Cisco 890 series
Integrated Services Routers (ISRs) to Ethernet devices, Power over Ethernet (PoE), and the network. The
chapter contains the following sections:
Preparing to Connect the Router, page 3-2
•
Connecting a PC, Server, or Workstation, page 3-3
•
Connecting a Phone, page 3-4
•
Connecting an External Ethernet Switch, page 3-5
•
Connecting the V.92 modem Port, page 3-6
•
Connecting a Terminal or PC to the Console Port, page 3-7
•
Connecting a Modem to the Auxiliary Port, page 3-8
•
Connecting the 3G Card, page 3-9
•
• Connecting a Data BRI Port, page 3-13
• Connecting an FE Line to an FE WAN Port, page 3-15
• Connecting an GE Line to an GE WAN Port, page 3-16
Connecting an xDSL Line, page 3-17
•
Connecting Power over Ethernet, page 3-18
•
Connecting the AC Adapter, page 3-18
•
Connecting an FXS Line, page 3-21
•
Connecting an FXO Line, page 3-23
•
Connecting a Voice ISDN BRI Line, page 3-24
•
Verifying Connections, page 3-26
•
For compliance and safety information, see Regulatory Compliance and Safety Information Roadmap
Note
that ships with the router and
SOHO Series Routers.
The illustrations in this chapter show a wireless router with antennas attached. Nonwireless routers do
Note
not have antennas or antenna connectors on the back panel. However, the procedures for connecting
devices to the router are the same for both wireless and nonwireless routers.
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
OL-16193-03
C H A P T E R
Regulatory Compliance and Safety Information for Cisco 800 Series and
3
3-1