Figure 5-3: Connect To The Ethernet Port; Figure 5-4: Connect To The Power; Figure 5-5: Check The Leds - Linksys WAP55AG - Wireless A+G Access Point User Manual

Dual-Band Wireless A + G Access Point
4. Connect the other end of the network cable to the Ethernet port on the back of the Access Point.
Click the Next button to continue, or the Back button to return to a previous screen.
5. Connect the power adapter to the Access Point's Power port. Then connect the other end to an electrical
outlet. Only use the power adapter supplied with the Access Point. Use of a different adapter can cause
product damage.
IMPORTANT: Make sure that you use the power
adapter that is supplied with the Access Point.
Use of a different power adapter could damage
the Access Point.
Click the Next button to continue, or the Back button to return to a previous screen.
6. The Access Point's LEDs should be lit. If not, re-check the connections.
Click the Next button to continue or Exit to exit the Setup Wizard.
Chapter 5: Setting Up the Dual-Band Wireless A + G Access Point
Setup Wizard

Figure 5-3: Connect to the Ethernet Port

Figure 5-4: Connect to the Power

Figure 5-5: Check the LEDs

10