Page 2
User Manual Consumer Notice: Please make sure you Baxi is a member of the Benchmark initiative and fully have carried out the simple checks detailed supports the aims of the programme. Benchmark has in these instructions before asking for a been introduced to improve the standards of installation Service Engineer to call, as a charge will be and commissioning of central heating systems in the UK...
Contents Introduction....................4 Thermostatic Controls..................5 Safety......................6 User Controls.......................7 To Operate the Boiler..................10 Boiler Protection Devices...................12 Frost Protection....................13 Annual Servicing....................14 Cleaning the Outside Casing Panels..............15 Care of Your Boiler and System................16 Fault Finding.......................19 Publication No. 27/18811...
Further information on this subject is given at a later stage. Samples of the Puma boilers have been examined by Gastec, a Netherlands Notified Body. The range is certified to comply with the essential requirements of the Gas...
within the appliance (a delay may be experienced at the tap depending on your system layout and length of pipework). The appliance uses a special water saving- cost reducing device which restricts the initial flow of water at the tap until the water is hot.
Safety If the appliance is installed in a compartment, do not use it for storage purposes and do not obstruct any purpose provided ventilation openings. If a gas leak or fault is suspected turn off the appliance and consult your Local Gas Supplier or Service Engineer.
User Controls All boiler mounted user controls are situated behind the pull down flap. The pressure gauge is located under the right hand side of the boiler. Publication No. 27/18811...
Page 8
Boiler Switch: This controls the operation of the boiler (Standby/On) 'Standby' sets the boiler Off. 'On' allows the boiler to produce hot water on demand. Central Heating Switch: 'Constant' sets the boiler to operate continuously on Central Heating. 'Timed' sets the boiler to operate for set periods as dictated by the optional timer.
Page 9
Central Heating Control: The lower control knob enables you to vary the temperature of the water as it flows from the appliance. Full movement of the knob corresponds approximately to a temperature range of 60 °C to 87 °C (140 °F to 188 °F).
To Operate the Boiler Ensure that the mains electricity to the boiler is on, the 'Mains' light will be illuminated. Central Heating Set the time controls to 'ON' and ensure that any room thermostat is calling for heat. Set the boiler switch to 'ON'. The boiler will light and operate in accordance with the pre-selected temperature set on the lower temperature control knob..
Page 11
Summer Use The boiler is designed to operate throughout the year. When central heating is no longer required set the Central Heating switch to the central 'OFF' position. This will allow the appliance to function normally for domestic hot water requirements whilst central heating is not available.
Boiler Protection Devices Reset Switch The reset switch should not be depressed while the boiler is operating normally. The boiler is fitted with several protection devices and operation of any of these will cause the boiler to 'Lockout' (the Lockout LED will illuminate). To Reset the Boiler Before resetting the boiler refer to the preliminary Fault Finding on page 19.
Important Gas and electricity are required to operate your boiler. Its performance will not be affected by normal variation in either supply, but a gas or electricity failure will put the boiler out of operation. It will automatically re-start when the supply is restored provided that the time clock and/or thermostats are in the 'On' position.
Note: Although the system can be emptied by using the drain off taps installed in the pipework around the system, to empty the boiler, it is necessary to remove the drain plug under the pump manifold. This should only be done by a competent person.
Cleaning the Outside Casing Panels The outside casing panels can be wiped when necessary by using a damp cloth to remove finger marks etc. Do not use an abrasive cleaner as this may damage the casing finish. Publication No. 27/18811...
Care of Your Boiler and System 1. Registration of Purchase It is important to register the purchase of your Baxi boiler to ensure you receive prompt and efficient handling in the event your boiler requires attention during the guarantee period. To register your guarantee simply complete and detach the Registration of Purchase form enclosed with these instructions.
Page 17
defect, on the appliance only (not the system or ancillary controls), free of charge for parts and labour, subject to there being no misuse or abuse. This does not affect your statutory rights. Service visits by Baxi Service Operations outside the terms of the boiler guarantee, will be charged for both parts and labour at our normal rates for chargeable work.
Page 18
4. Boiler Breakdown Insurance We are pleased to offer you the opportunity to protect your investment once your initial boiler guarantee has expired, by the payment of an annual premium. You can continue with this insurance for the normal life of your boiler and you will find a special 30 day introductory offer for additional years cover together with a card to register your purchase, as part of the “User Pack”...
Fault Finding In the event of your boiler not working there are several checks you should carry out before calling a Service Engineer as this could save you unnecessary expense. Observation Remedy The boiler fails to operate/no lights visible on the Check the electricity supply is on.
Page 20
The Internet Sales Enquiries: http://www.baxi.com Sales Operations http://www.potterton.co.uk Eastern Avenue, Team Valley Trading Estate, Gateshead. Brochure Hotline: Tyne & Wear. NE11 0PG. Tel: 0345 697509 Tel: 0191 491 7500 Fax: 0191 491 7568 Service Enquiries: Service Operations Brooks House, Coventry Road, Warwick.
Need help?
Do you have a question about the Puma and is the answer not in the manual?
Questions and answers