Little Giant Safety Step Manual

PROPER CARE AND STORAGE

• Store in a safe and dry place out of the weather.
• Keep clean and free of all foreign material.
• Examine all working parts for any damaged, worn, or missing parts.
• Keep steps dry and clean.

Watch for electrical wires. This Safety Step conducts electricity. Never allow yourself or the Safety Step to come in contact with live circuits.

INSPECTION

• Inspect upon receipt and before each use. Never climb a damaged, bent, or broken Safety Step; all parts must be in good working order.
• Make sure all rivets are tight and function properly.
• Keep your Safety Step clean and free from wet paint, mud, snow, grease, oil, and other slippery materials. Keep your shoes clean.
• Replace damaged, worn, or missing rubber feet and step tread as required to ensure safety.
• Never make temporary repairs of damaged or missing Safety Step parts.

READ ALL WARNING AND SAFETY LABELS

• Do not over-reach. Keep your body centered between both side rails. Do not lean sideways. Move Safety Step as needed.
• Face your Safety Step when climbing up or down.
• Open Safety Step fully before climbing.
• Wear slip-resistant shoes.
• Place your Safety Step on firm, level surface.
• The Safety Step is designed for one person use including materials or tools. Not to exceed 300 lbs.
• To protect children, do not leave Safety Step set up and unattended.
• Do not use the Safety Step if you tire easily or are subject to fainting spells, are using medi-cine, alcohol or drugs, or are physically handicapped.
• Do not use on ice, snow, or slippery surfaces without non-skid devices.
• Do not place your Safety Step on unstable surface or on scaffolding to gain additional height.
• Do not place in front of door opening that would swing toward Safety Step.
• Fully lock the handrail in the base hinge when the handrail is in the upright position. Keep your hands and fingers away from the hinge joint when locking.
• Manufacturer disclaims any liability or responsibility for damage or injury caused as a result of misuse of the Safety Step.
• If a leg or step is broken, if it doesn't function properly, or is exposed to fire or chemical corrosion, destroy the Safety Step.
• Read, understand, and comply with all supplied instructions before using this Safety Step.

300 lbs WORKING LOAD

TO OPEN

OPEN THE SAFETY STEP BY TILTING THE TOP STEP.


Handrail must be down to open the Safety Step.

TO CLOSE

CLOSE THE SAFETY STEP BY TILTING THE TOP STEP.


Handrail must be closed before the Safety Step can be placed in the storage position. Failure to do so may result in damage.