Little Giant LOCK TAB INNER Assembly

LOCK TAB INNER ASSEMBLY REPLACEMENT

READ THESE INSTRUCTIONS COMPLETELY BEFORE YOU START. IF YOU DON'T

UNDERSTAND THESE INSTRUCTIONS, PLEASE CALL 800-453-1192 FOR ASSISTANCE

ladders.

1. Failure to comply with all instructions may result in serious injury.

2. Make sure this kit is compatible with your ladder. If you have any questions concerning

the use of this kit on Little Giant Ladder Systems products, call 800-453-1192 for

assistance.

3. Before installing this kit, identify all kit components. If any components are missing or

damaged, please contact Customer Care. Do not substitute any components.

4. Inspect the ladder before installing this kit. Repair or replace any damaged or missing

ladder parts before using the ladder. Use only Little Giant Ladder Systems repair or

replacement parts. If you are unable to repair it, discard the ladder.

NOTE: IF ANY OTHER PART OF THE LADDER IS DAMAGED BEFORE OR DURING

THE PROCESS OF INSTALLING AND/OR REPAIRING, DISCARD THE LADDER OR

CONTACT CUSTOMER CARE FOR INSTRUCTIONS.

DO NOT USE A DAMAGED LADDER!

80401 v1 4.14 (1)

Table of Contents

Do you have a question about the LOCK TAB INNER and is the answer not in the manual?

Page 1 1. Failure to comply with all instructions may result in serious injury. 2. Make sure this kit is compatible with your ladder. If you have any questions concerning the use of this kit on Little Giant Ladder Systems products, call 800-453-1192 for assistance.
Page 2 1. Pull out lock tabs to disengage outer assembly 2. Remove the outer assembly. from inner assembly. 3. Repeat steps 1-2 on opposite side. Then discard old 4. Insert the new inner assembly into existing outer inner assembly. assembly. 5. Re-engage lock tabs to lock the outer assembly 6.