Sending Trigger Notifications By Http - Panasonic BL-C111A - Network Camera - Pan Operating Instructions Manual

2.5.2 Sending Trigger Notifications by HTTP

2.5.2 Sending Trigger Notifications by HTTP
The following screen is displayed while configuring the camera to buffer or transfer images by sensor or by
motion detection (see Page 30) if you select [Send HTTP Notification]. Follow the procedure below to send
trigger notifications via HTTP.
Note
•
If your computer network uses a proxy server, the appropriate proxy server settings must be made on
the [Network (IPv4)] page in order for images to be transferred by HTTP (see Page 87).
1.
Under [HTTP Notification], enter the URL of the HTTP server (max. 255 characters).
•
An IPv6 address can be entered.
2.
Enter the login ID
3.
Enter the password
4.
Enter the desired name
this file name.
•
Entering "\" allows you to specify existing directories on the server. For example, if you enter
"CameraNotifications\Notification" as the file name, the camera will upload files to the directory
"CameraNotifications" and save the files using the name "Notification".
5.
Select the desired setting for [Overwrite setting].
–
[Overwrite File]: The file on the server is replaced by the file uploaded by the camera, i.e., only 1 file
is saved on the server.
–
[Save as New File with Time Stamp]: A time stamp is added to the end of the file name, allowing multiple
files to be saved on the server. For example, if you set the file name as "Notification", an uploaded file
may be saved as "Notification20061231173020500".
The time stamp format is Year/Month/Date/24-hour time/Second/Millisecond.
Therefore, in this example, this notification was sent on December 31, 2006, at 5:30 PM and 20 seconds
and 500 milliseconds. Note that if you configure the camera to adjust its time setting for Daylight Saving
Time (see Page 95), an "s" will be inserted between the date and time of the time stamp.
6.
Click [Save], then click [Go to Trigger page].
48 Operating Instructions
(user name) required to access the server (max. 63 characters).
*1
required to access the server (max. 63 characters).
*1
for transferred files (max. 234 characters). Transferred files will be saved using
*2