Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for 3nStar PTA0140
Summary of Contents for 3nStar PTA0140
- Page 1 USER’S MANUAL PTA0140...
- Page 2 TABLE OF CONTENTS • Product Description • Product SIM Installations • Printing Instructions • Product Operations Guide...
- Page 3 DISCLAIMER DISCLAIMER To ensure the safe and correct use of this product, prevent danger, and avoid damage, please read this manual carefully before using the device and strictly follow the instructions. Check the equipment for any abnormalities before powering it on and using it. Keep this manual properly after reading for future guidance.
-
Page 4: Product Description
Product Description: Printer Scanner Printer button Second display Interface Funcional key Power key Volume key Fiscal room cover Main screen FEATURE DESCRIPTION Printer Integrated device for printing receipts and documents. Printer Button Button to initiate or stop printing operations. Allows the device to communicate wirelessly with other NFC-enabled devices for quick and secure transactions or data exchange. - Page 5 SIM card Slots PSAM Card slots Fiscal memory room TF Card slots FEATURE DESCRIPTION Short press: wake up the screen, lock the screen. Long press: long press for 2-3 second in power off mode to Power Key switch on the device. Long press for 2-3 seconds in normal operation mode to select power off or reboot.
- Page 6 Product SIM Installations: This section provides detailed instructions for powering on the device and installing SIM, PSAM, and TF cards. Follow these steps carefully to ensure proper setup and optimal performance of your device. Power On Long press the power key for about 3 seconds. SIM Card, PSAM Card, &...
-
Page 7: Additional Instructions
Additional Instructions: Ensure the card’s gold contacts are facing the corresponding contacts in the socket. Do not force the card into the slot. If it does not fit, check the orientation, and try again. Replace the battery cover once the card is securely in place. Printing Instructions: This device supports 80mm thermal paper with specifications of 80±0.5mm*80mm. - Page 8 Product Operations Guide: Card Reading 1. NFC Tag, put the NFC tag over the printer case of the device as shown below. Scan 1D / 2D Code 1. Place the electronic 1D/2D code, as you would with your cellphone, down towards the camera vertical as shown below.
- Page 9 Note: Fiscal Memory Room maximum size: 24mm x 37mm x 10.5mm. 5V_3V3_IO RS232_UART5_RTS RS232_UART5_RXD RS232_UART5_TXD TAX_DET_IO Lead Seal Screw Positions Illustration: The image shows the location of the lead seal screw, which should be removed to access the fiscal memory room. Removing Screws: Remove the screws from the bottom shell.
-
Page 10: Network Status Indicator
Network status indicator NETWORK STATUS INDICATOR NETWORK STATUS INDICATOR LIGHT Connection to Network Error Red Light Networking Flashing Yellow Light Networking Connection Successful Steady Green Light Data Transfers Flashing Green Light ACCESSORIES ACCESSORIES Main Device Power Adapter Printer Paper User Guide... - Page 11 • Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. • This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the PTA0140 and is the answer not in the manual?
Questions and answers