Jci1: Chassis Intrusion Connector; Jocfs1: Safe Boot Jumper - MSI 911-7E59-001 User Manual

JCI1: Chassis Intrusion Connector

This connector allows you to connect the chassis intrusion switch cable.
Using chassis intrusion detector
1. Connect the JCI1 connector to the chassis intrusion switch/ sensor on the chassis.
2. Close the chassis cover.
3. Go to BIOS > Security > Chassis Intrusion Configuration.
4. Set Chassis Intrusion to Enabled.
5. Press F10 to save and exit and then press the Enter key to select Yes.
6. Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
1. Go to BIOS > Security > Chassis Intrusion Configuration.
2. Set Chassis Intrusion to Reset.
3. Press F10 to save and exit and then press the Enter key to select Yes.

JOCFS1: Safe Boot Jumper

This jumper is used for Safe Boot. When this jumper is enabled, the system will boot
with default settings and lower PCIe (from CPU) mode.
Normal
(default)
Normal (default)
Boot with the saved
BIOS settings.
48
Trigger the chassis
intrusion event
Enabled
Apply the BIOS default
settings and lower PCIe
(from CPU) mode for
Safe Boot